★★★★★ 5
Sturdy and super strong
Color: Black-Mount
This product is very well made heavy duty no plastic parts basically all metal less than 1 % plastic.
Pro's holds monitors easily and one of mine weights 19.8 pounds according to the manufacture and the other one without stand that came with it weights 25 pounds don't know what they were thinking when they built that one hard to find arms to support that. But this arm system takes it like a pro yes you have to pay attention to which way you turn the adjustment screws but they are clearly marked. Had no problem assembling it or putting it together two installs one for a clamp on the edge one for a hole. I used the edge clamp and that beast is not coming off. I did tighten one side and then the other went back and forth between the two main screws until I got them equally tight to insure the monitors would not fall. They cost way more than this arm system.
Cons: There are 4 screws that hold the plate that holds the clamp screws plate. They are preinstalled and slip into a hole and slot configuration. Remove them completely and throw them out go to your local hardware store and get hardened screws they cost me about sixty cents apiece. I also got some washers and put them on the replacement bolts and affixed them so that the slot holes are basically just regular holes. I pushed the new screws down on the slot position and tightened. Now anyone that reads this I know is asking why? I'm 60 plus years old not a he-man or body builder never been actually been on the lighter side of strength. Not that I'm weak but in my day I have busted and broke things by overtightening those days are sadly gone. I did not use any extention or more commonly called a cheater bar on the allen wrench but 2 of the 4 screw heads stripped out and had to be removed with pliers. I also tried my set of allen wrenches on the screws thinking maybe cheap allen wrench no it was the screws that head that was I suspect too soft and it rounded out. Just pliers not vise grips so they were not terribly tight. I did not have to retap the holes so they were not cross threaded. 1 out of four that failed could be called a bad screw 2 out of four are cheap and not worth using and for that reason since they are a critical part of the clamp locking system I decided to get hardened screws which will probably not strip out or break the threads in the plate would probably tear out first and that would take some real doing. Outside of those screws and the expected failure of the cable holding plastic part that sits on the back of the clamp to hold cables and makes a nice place to store the allen keys to adjust the arm if needed that was a nice touch this thing is rock solid. Solution for the plastic cable holding part is simple a cable tie holds that in place yes it maybe a touch tacky but oh well hang me for wanting it to stay in place.
Yes, I would recommend this to someone and have
Yes, I think it is a good value
Yes, I think it is going to last a long time and the gas shocks seem to be strong
Yes, I would buy this again.
No, I do not think the problem I had should deter anyone from buying this just be aware that these screws might be soft and probably should be upgraded before assembling this thing the first time.
I would if the manufacture reads this recommend that they take a real good look at those screws and maybe see about getting a better grade. No I do not blame them they buy stuff and maybe not even be aware that the screws have a fair possibility of stripping out. But when someone puts $800.00 plus dollars on this it would really be stupid to have the problem I had and trust the other 2 screws to hold since I could not get 2 of them to tighten enough to take the wiggle out of the assembly.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 7, 2020
